Gunnebo RotaSec B120D, Инструкция по установке, эксплуатации и обслуживанию

Страница: 29 / 100

29
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
LCM02 Control Logic Board
The LCM02 board controls the system inputs and outputs either directly or through other boards to
which it interfaces.
The basic features of the board are as follows:

One input for unlocking the tripod for transit in direction A.

One input for unlocking the tripod for transit in direction B.

Two pairs of protected outputs for driving the signal lights (red and green) for directions
A and B.

Four outputs that can be directed to relays with voltage free contacts to provide an interface
with external components.

Fast acting fuse 5x20mm, 3. 15A/250V.

RS485 asynchronous serial line.

Four board mounted push buttons to program, reset and default of parameters.

Microprocessor reset button.

Operator interface comprising two 7-segment displays with decimal points and three
pushbuttons.
Start-up Functions
At the start-up, or when the equipment is switched on, the following functions/messages can be read
on the LCM02 displays.
SW 2 SW 3 SW 4 Result
OFF OFF OFF
It displays the status of 14 inputs
ON OFF OFF
It allows the parameter programming
SW2 : It changes from parameter number parameter value (Dot = num. parameter)
SW3 : Decreases the displayed number
SW4 : Increases the displayed number
OFF ON OFF
It displays the status of 14 inputs and the TX RX serial line status
SW2 : Red pictograms, red traffic lights, 2=1 relay on, 1 magnet on, buzzer off, display off.
SW3 : Green pictograms, green traffic lights, 2=1 relay on, 1 magnet on, buzzer off, display on.
SW4 : Pictogram, badge, traffic lights off, relay off magnets off, buzzer on, display = indser
OFF OFF ON
It visualises the status of 10 bit anagogical -digital converters
SW2 : It allows to select channel ADC
SW3 : It visualises the channel and the high part of the conversion
ON OFF ON
It initialises the equipment with the default parameters
Display visualises in By pressing
SW3 switch default type is selected (from 00 to 02)
One the default has been selected press SW4
If everything is OK display shows do, otherwise it shows Er.
Display A Display B
Segment
(Display B)
High Normal Low Normal
a Lock A Off Sensor 2 On
b Off
c Mat B Off Reader B Off
d Emergency Off
e Mat A Off Reader A Off
f Unlock A Off Sensor 1 Off
g Lock B Off
d.p. Rx Off Tx