Gunnebo RotaSec B120D, Инструкция по установке, эксплуатации и обслуживанию

Страница: 88 / 100

88
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Components
Annual Checks
(Operations to be carried out with the power supply and BBU disconnected)
Cables and Connectors
(Operations to be carried out with the power supply and BBU disconnected)

Check that the wire connectors are firmly attached.

Check that the terminals are fully tightened.

Check that the insulation of the wires is in good condition and that no conductors are exposed.

Check that mechanism fixings, screws and encoder grub screws are tight.

Carry out general testing as described previously.
Electrical Circuits
No general maintenance is required apart from replacement fuses in the event of a failure.
General Component Maintenance
Ensure the assembly is kept clean.
Replacing the LCM02
(Operations to be carried out with the power supply and BBU disconnected)
Note - Before removing the PCB, record the position of the Jumpers and Connectors.
When replacing ensure the correct EPROM configuration is refitted.

Disconnect the power supplies.

Remove all connectors from the PCB .

If necessary remove the PCB supports and the small chip in Master side LCM02.

Disconnect the flat cable from the UCM95 (if the PCB is fitted)

Connect the Jumpers to the NEW PCB.

Insert the original EPROM from the old unit to the NEW PCB.

Reconnect the cables and connectors.

Replace the PCB.

Reconnect the power supplies.

Switch ON the Unit and return it to normal operation.
Replacing the Infrared Sensor
(Operations to be carried out with the power supply and BBU disconnected)

Disconnect the power supplies.

Remove the infrared sensor from the support bracket.

Remove all cables from the infrared sensor, taking note of their location.

Reconnect the cables.

Replace the infrared sensor onto the mounting bracket.

Reconnect the power supplies.

Switch ON the Unit and return it to normal operation.
Note
– Adjust the infrared sensitivity to suit as detailed in Section 5
Replacing Other Interface Cards
(Operations to be carried out with the power supply and BBU
disconnected)
Other Interface Cards may be fitted as specified at time of order.
Follow the same good practice procedures as detailed above.