Gunnebo RotaSec B120D, Инструкция по установке, эксплуатации и обслуживанию

Страница: 89 / 100

89
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Down light
In the event that lamp replacement is necessary, remove the Down Light cover by unscrewing it and
lower the reflector assembly carefully. Remove and replace the lamp.
Note - Care should be taken with lamp replacement to ensure that the fingers do not come in
contact with the glass of the lamp
Fault Finding
During normal operation of the mechanism, the control logic displays the status of certain signals.
This enables rapid testing of certain system functions.
Fig 6.1 - Logic Display
Display A Display B Segment Display A Display B
a Status of sensor 2 of HC1/B board
b
Status of sensor 3 of HC1/B board
c
Input of reader permissive for
direction B
d
Up/Down encoder signal
e
Input of reader permissive for
direction A
f
Status of sensor 1 of HC1/B board
g Encoder step signal
dp
When the rotor rotates, the segments (f )and (a) flash as they reproduce the signals from the Hall
sensors located near the upper cam of the rotary unit.
When the rotor is in the barrier position, segment b should be illuminated.
Segments d and g also flash, but these reproduce the signals generated by the internal logic of the
LCM02 board.
In the presence of a direction A permissive signal from the reader, segment e will illuminate. If the
permissive signal is for direction B, segment c will illuminate.
LCM02 Outputs Test
The control logic can operate in a test mode in which it is possible to operate the lock electromagnets
and switch on and off the LCM02 display.

Press and hold pressed pushbutton SW3

Reset the microprocessor by pressing and releasing pushbutton SW1 .

Release the pushbutton SW3 .
At this point you can carry out the following tests.

Press SW2 to energise the direction A lock electromagnet, relays K2 and K4 of the LCM02
board are energised, all display segments are off.

Press SW3 to energise the direction B lock electromagnet, relays K1 and K3 of the LCM02
board are energised, all display segments on.

Press SW4 to de-energise the electromagnets.
Note - On completion of the test procedure you must press the reset button SW1 to restore
normal operation of the control logic.