Gunnebo RotaSec B120D, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 100

5
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Section 1 Introduction
Introduction
General
Please read this manual carefully, it contains information that will assist you with all aspects of
installation and maintenance, including unpacking. Correct installation & Maintenance will ensure
smooth functionality and increase the lifespan of components.
Gunnebo Entrance Control Ltd makes every effort to ensure that this manual is reviewed whenever
significant changes are made to the design. However, our policy of continuous improvement may
result in some small differences between the unit supplied and the description in this document.
Enquiries in this respect should, in the first instance, be directed to our Technical Department. .
Telephone
+44 (0) 1825 746105 , Fax + 44 (0) 1825 763835 ,
E-mail turnsupport.entrancecontrol@gunnebo.com
Electrical Warnings
The electrical power used in this equipment is at a voltage high enough to endanger life. Before
carrying out maintenance or repair, you must ensure that the equipment is isolated from the electrical
supply and sufficient tests made to verify that the isolation is complete.
When the supply cannot be disconnected, functional testing, maintenance and repair of the electrical
units are to be undertaken only by persons fully aware of the danger involved and who have taken
adequate precautions and training.
Errors
Reports on errors, comments and suggestions concerning this manual are requested and encouraged.
They should be submitted to:
Gunnebo Entrance Control Ltd, Bellbrook Business Park, Uckfield, East Sussex, TN22 1QQ, UK.
Tel
44 (0) 1825 761022 , Fax + 44 (0) 1825 763835 ,
E-mail turnsupport.entrancecontrol@gunnebo.com
Proprietary Notices
All data appearing herein is of a proprietary nature, with exclusive title to it held by Gunnebo. The
possession of this Manual and the use of the information are therefore restricted only to those persons
duly authorised by Gunnebo.
Do not reproduce, transcribe, store in a retrieval system or translate into any human or computer
language, any part of this Manual without prior permission of Gunnebo.
Hardware Changes
No hardware changes may be made without authority from Gunnebo who will be responsible for
ensuring that the proposed change is acceptable in all safety aspects. Personnel authorised by
Gunnebo may only make hardware changes.
Any maintenance or modification of Emergency Stop and Guarding Circuitry must be followed by
safety checks on the whole hardwired Emergency Stop and Guarding Circuitry.
Prior to a hardware change, records must be made of the change, one of which MUST be sent to the
Technical Department at Gunnebo.