Gunnebo RotaSec B120D, Инструкция по установке, эксплуатации и обслуживанию

Страница: 90 / 100

90
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Fault Finding
Symptom Check Action
Rotor will not park
Restoring and Damping
mechanisms

Adjust restoring mechanism

Adjust damping mechanism
if on maximum
setting replace with new.
Rotor over spins
Solenoids, Locking Pawls
and Sensor Card

Adjust solenoids

Adjust locking pawls, if faulty
replace.

Adjust damping mechanism
Unit locks up and will
not accept signals
Sensor card and Hall Effect
Magnets

Sensor card alignment

Hall Effect magnets

Cable connections
RotaSec fails to operate
Power supply problems

Check all electrical wiring for
security of connectors.

Check supply fuses are
serviceable.

Check Mains input supply is
correct

Check fuses on LCM02
Card reader (entrance
device) faulty

Check +24v is present at solenoids
when LED is illuminated.

Remove the GO signal and
simulate a signal from a known
working switch

Check wiring
(
If all correct the entrance device is at fault refer
to access control contractor)
Movement of Solenoids

Remove any obstructions

Carry out routine maintenance

Replace if faulty
Mechanism is noisy Timing Disc

Tighten screws holding down
Timing Disc.
Dead area sensing not
operating.
Infrared sensor

Adjust sensitivity, replace if faulty.
Down lights not
illuminated
Halogen down light

Check cables and transformer

Replace lamp if blown.