Gunnebo RotaSec B120D, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 100

16
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Important notices

Only one person at a time should pass through the turnstile.

Large packages should be carried in front of you.

Should any item become caught in the rotor, STOP, and DO NOT keep forcing through in the
same direction
Fail State
The RotaSec can be set to fail lock or fail safe in either direction via alteration of the solenoids and
programmable parameter. The fail state is the same as that when a fire alarm signal is received.
Access Control Devices
Gunnebo can supply the mounting for an Access Control Device, which is specified at the initial order
to meet customer requirements. Refer to Table 8.2.
Programmable Parameters
The system operation is conditioned by the values given to certain parameters stored in the LCM02
PCB.
When the control logic microprocessor executes the program it verifies the values of the specific
programmed parameters which sets the operation and function of the unit.
The values of these parameters can be adjusted or reset to a standard configuration by following the
procedures given.
Listed in Table 8.2 are the parameters together with their locations and functional descriptions.
Masks
The value of some of the parameters can be worked out by converting the hexadecimal value in to a
binary value and then consider the value of each digit separately.
The location parameters from 00 to 07 allow signals to be directed to the individual relays of the
LCM02 PCB. Refer to Table 8.2 for Parameter Values and Section 4 for instructions to enable
changes.