Gunnebo RotaSec B120D, Инструкция по установке, эксплуатации и обслуживанию

Страница: 33 / 100

33
.............................
CCEC/ OM Manual RotaSec Titan 1.5 EN 08.2009
Voltage Free Outputs
The four relays K1, K2, K3 and K4 control an equal number of voltage free contacts that interface the
control logic with external components. The maximum capacity of the contacts is 0.5A max/30V.
Note - The output contacts may be configured individually for normally open (NO) or normally
closed (NC) operation by suitably positioning the jumpers JP05, JP07, JP10 and JP12.
The logical function of the four outputs is dependent on the values set for certain programmable
parameters, Refer to the OPERATING SECTION of this manual.
Sensor Board
The board provides an interface between the Titan mechanism and the LCM02 Controller Logic.
Mounted on it are the position sensors for the rotary unit and all the connections required to
operate the solenoids.
The sensor PCB assembly is fitted with a 5 way male connector.
Communication with the LCM02 PCB is made by means of a cable to the Board. This cable carries
+24Vdc for the Board supply, sensor signals and the commands for all solenoids.
Fig 4.14 - Sensor Board
LEDs
The board has 3 status LED‟s that indicate the operating status of the mechanism.
LED Colour Function Description
DL1 Green Status of Hall sensor 1 On when sensor engaged
DL2 Green Status of Hall sensor 2 On when sensor engaged
DL3 Green Status of Hall sensor 3 On when sensor engaged