The Roll-Up III
10
Installation
Power
Serial
Transducer
Serial Connection
Computer
1
Plug the power supply into an AC outlet. Connect the power supply
to the appropriate jack on the Connector Panel. The digitizer will
beep four short tones (see the
Roll-Up III Tones
section on page 23 for
a complete table of Roll-Up III tones), indicating it is powered On.
2
Connect the RS232 serial cable to the serial jack on the Connector
Panel. The connector is keyed and will fit only the correct jack. Do not
force it.
3
Configure the SuperSet Code. The Roll-Up III comes from the factory
with the SuperSet Code
pre-configured. (See
Using the
SuperSet Menu.
)
RS232 Serial Connection
If your software application is not Wintab-compliant, be sure to set the
correct two-digit Application SuperSet Code before connecting the serial
cable to the computer. SuperSet Codes can be found in Table 1. If your
application is not listed in Table 1, find the configuration settings that
apply to your application in Table 2 and use the corresponding SuperSet
Code. If an appropriate SuperSet Code is not listed in Table 2, use the
Custom Configuration Menu stored in the slot on the end of the Roll-Up
III housing to configure your Roll-Up III.
