7
The Roll-Up III
Installation
Software Configuration
Software drivers provide the communication bridge between your digitiz-
ing software application and your Roll-Up III. You should install only the
drivers necessary for the Roll-Up III to work with your application soft-
ware. The GTCO CalComp-supplied
TabletWorks
CD supports
reduced
functionality Wintab
and
TabCon
-compatible applications. If you are not
sure which drivers are required, check Table 1 on page 14, or consult
with your application vendor. A driver does not need to be installed if
you are using the Roll-Up III with the GTCO CalComp QuikRuler III.
Configuring Non-Wintab Applications
Many application programs provide configuration information for specific
digitizers. If the Roll-Up III digitizer is not listed, you can use the configura-
tion for GTCO Digi-Pad Type 5 or Type 5A (T5/T5A), Roll-Up II, CalComp
9100/9500, or Summagraphics Microgrid III or ID Series.
Installing the TabletWorks Driver
Insert the CD into the CD-ROM drive on your computer. The installer will
autoload. If it doesn’t, click on the
Start
button on the Windows Task Bar
and select
Run
from the menu. Type
X:\setup.exe
(
X
represents the CD
drive letter). Follow the onscreen prompts to complete the installation.
A TabletWorks icon
will display in the System Tray on the Windows
Task Bar. Right-click on the icon to display the TabletWorks Menu, which
provides access to all the TabletWorks features.
Setting Up Your Roll-Up III
The instructions below describe how to set up your Roll-Up III. Before
you begin, please take a moment to fill out and mail the Warranty Regis-
tration Card.
