GST I-9105R, Инструкция по установке и эксплуатации

Страница: 19 / 26

I-9105R
Intelligent Reflective Beam Detector
Installation and Operation Manual
The Intelligent Solution
17
z
Press Up , the screen shows sensitivity level and device type in
sequence.
z
Press Down , the screen shows above contents in opposite
way
2. Setting Address Code
The detector offers address code programming for field application.
Refer to operation below:
z
Enter I
2
C programming code, and the screen is a “0”.
z
Input address code for programming
（
1
～
242
）
.
z
Press Program to start programming. “P” will be shown when
successful, otherwise an “E” will be shown.
z
If programming is successful, press Clear , the screen will
show a “0”, and you can go on with further operations.
z
If programming fails, press Clear , the screen will show a “0”,
input address code once more.
3. Setting Sensitivity Level
The hand held programmer can set two sensitivity levels to the
detector. 2 is sensitivity one, and 3 is sensitivity two, referring to
detailed operations below:
z
Enter I
2
C programming mode of hand held programmer, and
the screen shows a “0”.
z
Input unlock password, press Clear , and open the lock.
z
Press Function then the figure “3”, the screen shows a “
－
”.
z
Input sensitivity level to be set, and press Program to begin
programming. The screen will show a “P” when if
programming is successful, otherwise it will show an “E”.
z
Clear pressed, the screen shows “0”, and you can go on with
further operations.
4. Setting the Device Type
You can also set the device type of the detector through a
programmer, referring detailed operations below: