GSi VersaLoop, Руководство пользователя, Страница: 36 / 52

Chapter 6: Maintenance and Troubleshooting
VersaLoop™ – Gearbox Mounting Process
The following steps should be followed when assembling the gearbox on the opposite side to the drive
end.
1. Remove socket cap screws attaching the gearbox flange to the gearbox and set aside (needed for
opposite side mounting).
2. Remove the gear box flange from the gearbox.
3. If spring pins remain in the gearbox, grind them level to the gearbox housing. This must be done in
order to fit shaft cover to gearbox housing.
Figure 6-3 Gearbox flange removal
A
Socket cap screw
C
Spring pin
B
Gearbox flange
D
Gearbox
4. Locate new spring pins from the drive hardware kit and position them in the opposite side of the
gearbox.
5. Align flange with spring pins and mounting holes.
6. If needed press the flange down onto spring pins.
7. Insert socket cap screws in flange holes and tighten
8. For instructions to mount the gear box onto the drive end assembly, see Gearbox and Motor – Instal-
lation, page 21 .
36 Pneg-1966 VersaLoop™