GSi VersaLoop, Руководство пользователя, Страница: 22 / 52

Chapter 4: Assembly
Table 4-1 Drive Kits
Motor Specification Drive Kit
5 HP DBR-000029
10 HP DBR-000034
15 – 20 HP DBR-000030
25 – 30 HP DBR-000031
Non-drive End – Installation
1. Locate the non-drive end (A) and position it on the ground or stand.
2. Position the connecting band (B) either on the tubes in the non-drive end (A) or on the assembled
tube section (C) (upper and lower tubes).
3. Join one end of the tube section (C) (upper and lower tubes) to the tube sections in the non-drive end
(A).
4. Center the connecting band (B) over the tube section connections.
5. Position the joint of the connecting band (B) so that the overhanging lip will shed water and not direct
it to the tube.
6. Install the bolts (D) and nuts (E) per each connecting band (B).
Figure 4-5 Installing the non-drive end
A Non-drive end D 3/8 x 1 1/2 in. bolt
B
Connecting band
E
3/8 nut
C Tube section
22 Pneg-1966 VersaLoop™