GSi VersaLoop, Руководство пользователя, Страница: 17 / 52

4
Assembly
Topics Covered in this Chapter
▪ VersaLoop™ – Typical Layout
▪ Tube Section – Assembly
▪ Gearbox and Motor – Installation
▪ Non-drive End – Installation
▪ Drive End – Installation
▪ Chain and Paddles – Installation
VersaLoop™ – Typical Layout
The following steps should be followed when assembling a horizontal or inclined unit.
1. Layout tube sections (C) and determine the inlet and outlets. Refer to Tube Section – Assembly,
page 19 .
2. Install the gear box (E) and motor (D) to the center shaft of the drive end section (A). Refer to Gear-
box and Motor – Installation, page 21 .The right hand/left hand orientation is determined by the layout.
3. Install the tube sections (C) and drive end (A) section into location. Refer to Drive End – Installation,
page 23 .
4. Install the other end of the tube sections (C) to the non-drive end (B). Refer to Non-drive End – Instal-
lation, page 22 .
5. Install chains and paddles into the tube section (C) from the drive end section.
6. Tighten the VersaLoop™ chain.
7. Attach the inlet hopper (if equipped). Refer to Hopper – Installation, page 27 .
8. Attach the discharge spout (if equipped). Refer to Discharge Spout – Installation, page 28 .
Pneg-1966 VersaLoop™ 17