GENO
®
-flushing compressor 1988 K
Order no. 015 151 963-inter Created: KONS-gmei-mrie G:\BA-151963-INTER_GENO-SPUELKOMP-1988_K.DOC
8
4.4 Protection from water damage
Warning!
In order to properly protect the installation site from water
damage:
1.
a sufficiently dimensioned floor drain system must be available or
2.
work must be continually supervised.
4.5 Indication of
specific dangers
Danger due to electrical energy!
Do not touch electrical parts with wet hands.
Disconnect the system from mains before starting work on electrical
parts of the system. Have qualified experts replace damaged cables
immediately.
Danger due to mechanical energy!
System parts may be subject to overpressure. Danger of injury and
damage to property due to escaping water and unexpected movement
of system parts. Check pressure pipes regularly. Depressurise the system
before starting repair or maintenance work on the system.
Hazardous to health due to contaminated drinking water!
Have the system installed and operated by a specialist company. The
operation manual must be strictly adhered to! Inspections and
maintenance must be performed at the intervals specified!
Particular dangers on the compressor aggregate!
Warning!
1.
Do not operate the flushing compressor below 5°C. If the flushing
compressor is undercooled – without connection voltage – wait until
the temperature has adjusted.
2.
The compressor aggregate and lines become very hot when
operated and remain hot for some time after being switched off.
Contact with hot parts results in burns. It must be ensured that no
flammable materials are allowed to come into contact with these
parts.
3.
The flushing compressor may only be operated in a well-ventilated
and dust-free room. The air sucked in by the compressor aggregate
must not contain flammable vapours or mist, e.g., paint solvents,
which could lead to a fire or explosion.
4.
The cooling air flow on the compressor aggregate must not be
blocked. The system must thus be set up a distance of at least 50 cm
from any obstacles.
