Grizzly G0819, Руководство пользователя

Страница: 58 / 84

-56-
Model G0819 (Mfd. Since 09/16)
Tool Needed: Qty
Open-End Wrench 19mm .................................. 1
To adjust conveyor belt tracking:
1. Turn conveyor belt ON.
— If conveyor belt is tracking to the right,
rotate the right adjustment bolt (see
Figure 90
) clockwise.
— If conveyor belt is tracking to the left, rotate
the left adjustment bolt (see
Figure 90 )
clockwise.
Adjusting Conveyor
Belt Tracking
Adjust conveyor belt tension before adjust-
ing conveyor belt tracking.
The conveyor belt is tracking properly when it
stays centered on its rollers during operation and
does not wander from side to side. The tracking is
adjusted by rotating either the left or right convey-
or belt tension adjustment bolt
(see Figure 90) ,
depending on the needs of the adjustment.
In addition, two guide wheels (see
Figure 91)
pro-
tect the conveyor belt from damage if the tracking
is out of adjustment, by preventing it from rubbing
against the inside surfaces of the conveyor table.
Figure 91. Conveyor belt guide wheels
(Emergency Stop plate removed for clarity).
Guide Wheel
(1 of 2 shown)
2. Run conveyor belt for 3–5 minutes and
recheck tracking.
3. Repeat Steps 1–2, as necessary, until con-
veyor belt is properly tracking.
Note:
The edge of the conveyor belt should
just touch the guide wheels as shown in
Figure 91 on Page This Page.
Calibrating Scale
Pointer
For the scale pointer to be accurate, it must be
calibrated. We recommend calibrating your scale
pointer anytime you adjust the table elevation
leadscrews.
Tools Needed: Qty
Phillips Head Screwdriver #2 .............................1
To calibrate scale pointer:
1. Sand workpiece and measure workpiece
thickness.
2. Loosen screws that secure scale pointer
(see
Figure 92), adjust it to thickness of
workpiece, then tighten it.
Figure 92. Scale pointer screws location.
Screws