Grizzly G0819, Руководство пользователя

Страница: 48 / 84

-46-
Model G0819 (Mfd. Since 09/16)
6. Remove (6) M5-.8 x 15 Phillips head screws,
diaphragm cover, and diaphragm (see
Figures 68–69)
.
7. Remove (1) M6-1 x 12 cap screw, then
remove right brake pad (see
Figure 70
).
4. Using a fine ruler, measure thickness of each
brake pad. The brake pads consist of a metal
plate with a composite pad. Measure thick-
ness of composite pads only
(see Figure 66 ) .
Note: If you have difficulty measuring the
brake pads while the disc brake assem-
bly is mounted to the machine, proceed to
Step 5, and then measure the brake pads
after removing the disc brake assembly.
— If both of the pads are greater than
1
⁄
8
"
(see
Figure 66
), the pads do not need to
be replaced. Proceed to Step 12.
— If one of the pads is less than
1
⁄
8
" (see
Figure 66
), replace both pads. Proceed to
Step 5 .
Figure 66. Brake pad detail.
Min
1
⁄
8
"
5. Remove two mounting bolts that secure disc
brake assembly to machine (see
Figure 67
),
then pull disc brake assembly away from
rotor. If you have not done so already, follow
Step 4 to measure brake pads.
Figure 67. Location of disc brake assembly
mounting bolts (1 of 2 shown).
Mounting
Bolt
(1 of 2)
Figure 69. Diaphragm removed from disc brake
assembly.
Figure 70. Location of right brake pad and
mounting cap screw.
Figure 68. Location of diaphragm cover.
x 6
Diaphragm
Brake
Assembly
Diaphragm
Cover
x 1
Right
Brake Pad