Grizzly G0819, Руководство пользователя

Страница: 25 / 84

Model G0819 (Mfd. Since 09/16)
-23-
7. Press
sanding belt start button
(see Figure 27 on Page 22) to turn main
motor
ON. Verify motor starts up and runs
smoothly without any unusual problems or
noises.
8. Press Emergency Stop button to turn machine
OFF.
9. WITHOUT resetting Emergency Stop button,
try to start main motor by pressing Sanding
Belt Start button. Main motor should not start.
— If the main motor does not start, the safety
feature of Emergency Stop button is work-
ing correctly. Proceed to
Step 10.
— If the main motor does start, immediately
turn it
OFF and disconnect power. The
safety feature of the Emergency Stop
button is NOT working properly. This
must be troubleshot and fixed before
using the machine further. (Refer to
Troubleshooting on Page 40).
10. Repeat Steps 6–9 with conveyor belt start
button (see
Figure 27 on Page 22) to test
feed motor.
The conveyor motor should run smoothly and
without unusual problems or noises, and the
belt should move away from the operator and
toward the sanding drums.
11. Reset Emergency Stop button.
Figure 29. Location of Emergency Stop Plate.
Emergency
Stop Plate
— If the sanding belt and conveyor belt come
to a complete stop, the safety feature of
the Emergency Stop plate is working cor-
rectly.
— If the sanding belt and conveyor belt do
not come to a complete stop, immediately
disconnect power. The safety feature of
the Emergency Stop plate is NOT work-
ing properly. This must be troubleshot
and fixed before the machine can be used
further.
Congratulations! The Test Run is complete.
12. Press sanding belt start button and conveyor
belt start button, then press Emergency Stop
plate (see
Figure 29).