Grizzly G0812, Руководство пользователя

Страница: 61 / 84

Model G0812 (Mfd. Since 2/16)
-59-
5. Connect machine to power and lower head-
stock all the way until it stops moving.
6. DISCONNECT MACHINE FROM POWER
and place a 90° square flat on table and
against both fixed vise jaw and blade, as
shown in
Figure 92. The square should fit
snugly against fixed jaw and blade.
— If square fits snugly against fixed jaw and
blade, no further steps are necessary
.
— If square does not fit snugly against sta-
tionary jaw and blade, rotate flip-stop out
to disengage it, and loosen jam nut shown
in
Figure 93. Thread stop bolt inward or
outward as necessary, then re-engage
flip-stop.
Figure 92. Testing vise/blade squareness.
Figure 93. Flip-stop bolt and jam nut location.
Stop Bolt
7. Rotate headstock until turret stops against
flip-stop bolt. Blade should be square to vise.
8. Repeat Steps 6–7 as necessary, then tighten
jam nut against stop block (see Figure 93)
without turning stop bolt.
Setting 45° Right Angle Stop
1. Raise headstock to highest position.
2. DISCONNECT MACHINE FROM POWER!
3. Rotate flip-stop out completely (see
Figure 93).
4. Rotate swivel lock handle toward base, then
rotate headstock counterclockwise until base
contacts 45° stop bolt (see
Figure 94).
5. Slide vise to left position and secure it. Refer
to Changing Vise Position on Page 34.
6. Connect machine to power and lower head-
stock all the way until it stops moving.
7. DISCONNECT MACHINE FROM POWER
and place 45° square between vise jaw and
blade, as shown in
Figure 95. The square
should fit snugly against outer fixed jaw and
blade.
Figure 95. Using 60° square to check 45° stop.
Figure 94. 45° right stop bolt and jam nut
location.
Stop Block
Jam Nut
Jam Nut
45° Right Stop Bolt
Swivel Lock
Handle
Fixed Vise Jaw
Blade
Square
Blade
Outer
Fixed Jaw
45° Square