-56-
Model G0812 (Mfd. Since 2/16)
This adjustment has been made at the factory
and should not need to be adjusted under normal
circumstances. However, if you find the saw is not
cutting square, you may need to adjust the blade.
Only make this adjustment after factors such as
excessive feed rate or the blade guide being set
too far away from the workpiece have been ruled
out.
Tools Needed
Qty
Hex Wrench 3mm .............................................. 1
Hex Wrench 6mm .............................................. 1
Machinist Square ............................................... 1
To square blade with table:
1. Lower headstock until it contacts downfeed
stop bolt (refer to
Page 54).
2. DISCONNECT MACHINE FROM POWER!
3. Place square on table bed and against edge
of blade (see
Figure 84), and check different
points along length of table between blade
guide assemblies.
Figure 84. Checking blade-to-table squareness.
4. Re-tighten cap screws loosened earlier.
5. Repeat Step 3 and adjustments above as
necessary until blade is perfectly square to
table.
Tip: Cut small section from scrap piece of
material with known square end and mea-
sure for uniform thickness. If thickness is not
uniform, repeat adjustments above until your
personal requirements are met.
— If blade is square with table, no further
adjustments need to be made.
— If blade is not square with table, loosen
two cap screws shown in
Figure 85 one
to two turns and repeat on second blade
guide assembly, then turn set screws on
blade guides as necessary until blade is
perpendicular to bed.
Figure 85. Screws for adjusting blade-to-table
squareness.
Set
Screws
(1 of 2)
Squaring Blade with
Table
Square
1 of 2
Содержание G0812
Страница 84: ......
