Grizzly G0812, Руководство пользователя

Страница: 60 / 84

-58-
Model G0812 (Mfd. Since 2/16)
Figure 89. Lower limit switch controls.
Lower Limit
Switch
Scale
Roller
Plunger
Indicator
The swivel base is equipped with three angle
stops to provide quick adjustments to 60° to the
left, 0°, and 45° to the right. If cuts made using
these stops are not sufficiently accurate, the stops
will need to be adjusted.
Tools Needed Qty
Open-End Wrench 12mm .................................. 1
Open-End Wrench 14mm .................................. 1
45° Square ........................................................ 1
60° Square ........................................................ 1
90° Square ........................................................ 1
Angle Stops
5. Connect machine to power and repeat Steps
1–4 until upper limit switch works correctly.
3. Loosen Phillips head screws and hex nuts
that secure upper limit switch (see Figure 88).
4. Adjust upper limit switch so roller plunger is
depressed against feed stop (see
Figure 88),
then tighten screws and hex nuts.
Figure 88. Upper limit switch and feed stop.
(1 of 2)
Feed Stop
Upper Limit
Switch
Roller
Plunger
Figure 90. Swivel lock handle location.
4. While standing by motor, rotate headstock to
right approximately 5°, rotate flip-stop inward
to engage it (see
Figure 91), then rotate
headstock to left until turret just contacts stop
bolt.
Figure 91. Flip-stop engaged.
1. Raise headstock to highest position.
2. DISCONNECT MACHINE FROM POWER!
3. Rotate swivel lock handle (see Figure 90)
toward base.
Setting 0° (90°) Angle Stop
8. Raise headstock. It should automatically stop
at approximate height previously set on scale.
Adjust limit switch position as needed to fine
tune the height setting for your workpiece.
6. Without running blade, lower headstock to
lowest position.
7. Loosen auto stop lever (see Figure 89),
adjust lower limit switch until white indica-
tor aligns with approximate cutting height
marked in inches on scale.
Feed Stop
Auto Stop
Lever
Flip-Stop Turret
Stop Bolt
Swivel Lock
Handle