Grizzly G0812, Руководство пользователя

Страница: 34 / 84

-32-
Model G0812 (Mfd. Since 2/16)
The speed at which the saw blade will cut through
a workpiece is controlled by blade type, feed rate,
and feed pressure. The feed rate is controlled by
the feed rate dial on the control panel.
Note: If a lubricant is used on the cut, the feed
rate can be increased by approximately 15%.
Feed Rate
To set feed rate:
1. Raise headstock to highest position.
2. Adjust feed rate dial shown in Figure 36
to desired feed rate from 0 (slowest) to
10 (fastest).
The Model G0812 is equipped with a work stop for
repetitive cutting operations up to 16" long.
Tools Needed Qty
Hex Wrench 4mm .............................................. 1
Hex Wrench 6mm .............................................. 1
Work Stop
Setting Work Stop
1. Lower headstock completely.
2. DISCONNECT MACHINE FROM POWER!
3. Loosen set screws shown in Figures 37–38.
Figure 38. Location of rear set screw for setting
stop rod flush with vise bed casting.
Set Screw
Figure 37. Location of front set screw for setting
stop rod.
4. Slide work stop rod into hole in base on side
required for cutting workpiece.
5. Adjust work stop rod so it is flush with back of
vise bed casting, as shown in Figure 38.
3. Proceed with cutting operations.
4. Examine metal chips created from cutting
operation, and adjust feed rate as necessary
for optimum cutting performance (refer to
Chip Inspection Chart on Page 31 for more
details).
Figure 36. Feed rate dial.
Feed Rate Dial
Work Stop
Rod
Work Stop
Rod
Cap Screw
Set Screw