
Model G0806/G0807 (Mfd. Since 12/15)
-51-
If the blade guide post does not raise and lower
exactly parallel with the blade, the clearances
between the blade guides and blade will change
as the guide post is moved, causing rubbing,
wear, and blade deflection. Blade guide clearance
must stay the same when the guide post is raised
and lowered along its full length of travel.
Tools Needed
Qty
Hex Wrench 5mm .............................................. 1
Hex Wrench 6mm .............................................. 1
To align the guide post:
1. DISCONNECT BANDSAW FROM POWER!
2. Make sure the blade tracking and tension are
set correctly (refer to
Page 23).
3. Lower the blade guide post to the bottom of
its travel and lock it in place.
4. Adjust the blade guides as described on
Page 25.
5. Unlock the post just enough to allow it to
slide, move it all the way up, then examine
the clearances between the blade and blade
guides to see if they changed.
Guide Post
Alignment
6. Loosen the four receiver cap screws (see
Figure 65).
7. Adjust the four set screws to tilt the blade
guide receiver in the required direction.
8. Tighten the cap screws and recheck blade
guide clearance along the guide post path of
travel.
9. Repeat this procedure if necessary to fine-
tune the guide post travel to acceptable toler-
ances.
Figure 65. Guide post alignment controls.
Receiver
Cap
Screws
Set
Screws
Figure 64. Guide post system.
Guide
Post
Receiver
Note: If these clearances changed beyond
your acceptable tolerances, the blade guide
receiver (see
Figure 64) can be adjusted to
fix this condition.
Содержание G0806
Страница 80: ......