Grizzly G0806, Руководство пользователя, Страница: 28 / 80

-26-
Model G0806/G0807 (Mfd. Since 12/15)
Blade Support Adjustment
The blade support is a round rod that is positioned
0.016" behind the blade to support it while cutting.
Tools Needed Qty
Hex Wrench 3mm, 5mm ...........................1 Each
Feeler Gauge 0.016" .......................................... 1
Dollar Bill (instead of feeler gauge)* .................. 1
*A dollar bill folded twice (four thicknesses) is
approximately 0.016".
To adjust the blade support:
1. DISCONNECT BANDSAW FROM POWER!
2. Remove the blade guard.
3. Loosen the blade guide bracket cap screw on
the guide post (see Figure 29).
Blade
Support
Blade Guides
& Bracket
0.016"
Blade
Blade Guide
Bracket
Cap Screw
Blade Support
Adjustment Cap Screw
Figure 29. Blade guides and bracket positioned
away from blade.
4. Move the blade guide bracket (with the
guides) away from the blade so that only the
blade support is near the blade, as illustrated
in
Figure 29.
5. Loosen the blade support adjustment cap
screw on the guide post.
6. Using a feeler gauge or a dollar bill as a
gauge, position the blade support 0.016"
behind the blade.
7. Retighten the blade support adjustment cap
screw to secure the setting.
8. Perform the Blade Guide Adjustments pro-
cedure in the next subsection.
9. Re-install the blade guard.
Note: Ensure blade guard does not contact
upper wheel or blade.
Blade Guide Adjustments
The blade guides should be positioned 0.004"
away from each side of the blade and
1
⁄
16
" behind
the teeth gullets.
The goal is to position the guides as close as
possible to the blade from side-to-side without
touching it. The guides are positioned behind the
teeth gullets to provide support without allowing
the guides to ruin the teeth set when the blade is
pushed back during cutting.
Tools Needed Qty
Hex Wrench 3mm, 5mm ...........................1 Each
Phillips Head Screwdriver #2 ............................ 1
Feeler Gauges 0.004" ....................................... 1
Dollar Bill (instead of feeler gauge)* .................. 1
Fine Ruler .......................................................... 1
*The thickness of a dollar bill is approximately
0.004", so it can be used in the place of the 0.004"
feeler gauge.
To adjust the blade guides:
1. DISCONNECT BANDSAW FROM POWER!
2. Remove the blade guard.
3. Make sure the blade support is correct-
ly positioned behind the blade (refer to
Blade Support Adjustment in the previous
subsection).
4. Make sure the blade guide bracket cap
screw is loose (see Figure 29).