Grizzly G0806, Руководство пользователя, Страница: 46 / 80

-44-
Model G0806/G0807 (Mfd. Since 12/15)
Grease Type ......... T26419 or NLGI#2 Equivalent
Amount .................................................Thin Coat
Lubrication Frequency ....................... As Needed
If the table becomes difficult to tilt, position it so
that you can brush a thin coat of multi-purpose
grease on the trunnion sliding surfaces (see
Figure 57), then move the table back and forth to
distribute.
Oil Type ..............................................Air Tool Oil
Amount .............................................. Four Drops
Lubrication Frequency .................. Every 4 Hours
Trunnion Sliding Surfaces Air Pump
Figure 57. Trunnion lubrication.
The sliding surfaces on the guide post (see
Figure
58) may occasionally need to be lubricated if the
movement becomes stiff.
Figure 58. Guide post lubrication location.
Oil
Guide Post Sliding Surfaces
Oil Type ................................... Light Machine Oil
Amount .................................................Thin Coat
Lubrication Frequency .....................Occasionally
Periodically dress the grinding wheel to square it
up and renew the abrasive surface. Dressing is
done in the same manner as a typical grinding
operation but using a diamond-tipped dressing
tool (see
Figure 60).
Figure 60. Example of diamond dressing tools.
Dressing Grinding
Wheel
To lubricate the air pump:
1. Open the rear access panel.
2. Remove the air line from the fitting (see
Figure 59), add two drops of quality air tool
oil to the fitting, then re-install the air line.
3. Clean away any oil from outside the air pump,
bandsaw frame, or floor.
4. Close and secure the rear access panel.
Figure 59. Drive system lubrication points.
Air
Fitting
Trunnion Sliding
Surfaces