GRAUPNER mx-20 Hott, Руководство по программированию

Страница: 257 / 296

257 Detail program description - Control adjust
to enable a "smooth" transition of the various servo
positions. Thus, an increased stress of the model under
certain circumstances with a "hard" change of rudder
or fl ap positions, for example, is prevented The "Status"
column shows you the currently active fl ight phase with
an asterisk "

".
2. Step
In order to actually be able to switch between the
individual fl ight phases, the assignment of one or
multiple switches is necessary. One of the two three-
stage switches (CTRL 9 or CTRL 10) is best suited for
switching of up to three fl ight phases.
Each of the two switch limit positions is assigned to
one of the fl ight phase switches A ... F,
starting from
the center position . The assignment of the switch takes
place in the menu ...
"Phase assignment" (page 134)
First select "C" with the marking frame. The briefl y press
the central
SET key of the right touch pad and move
the switch from the center position to a limit position, for
example, downward:
PHASE ASSIGNMENT
A B C D E F
1 Nor mal
2 6 7
prior combi
Move the switch back to the center position and then
select "D", and after activation of the switch assignment,
move the switch to the other limit position, for example,
to the top:
PHASE ASSIGNMENT
A B C D E F
1 Nor mal
2 6 7
prior combi
Now the three-stage switch is programmed.
Now and additional switch could be assigned for the
"start" fl ight phase, if applicable. In this case under "A",
so that the "start" phase is always switched to from
every other fl ight phase in parallel to the switching-on of
the motor:
A B C D E F
1 Nor mal
2 6 7
PHASE ASSIGNMENT
prior combi
Then the respective switch positions must be assigned
corresponding fl ight phases (names). Although you have
already assigned names for some fl ight phases, the
phase name "1 normal" still appears in the right of the
display; see the fi gures above.
First move the three-stage switch to the limit position,
for example to the top, and switch with the marking
frame in the display down to the right to the value fi eld
for the fl ight phase name. Briefl y press the central
SET
key of the right touch pad for the activation of the input
fi eld and select the desired fl ight phase for this switch
position, in this example "2 Thermal", with the arrow
keys:
A B C D E F
2 6 7
2 Ther mal
PHASE ASSIGNMENT
prior combi
Proceed in the same manner for the other switch limit
position, which is assigned the name "3 Speed".
If applicable move Switch 2 and assign this switch
combination the name "4 Start".
Briefl y pressing the central
ESC of the left touch pad or
the central SET key of the right touch pad completes the
time name assignment.
The fl ight-phase dependent model settings made before
the assignment of phase switches are now in the fl ight
phase "1 Normal". This is the phase which is called
with the open "Start" switch in the center position of the
three-stage switch.
3. Step
In order to not have to carry out all previously made
settings for the model in the "new" fl ight phase from
the ground up, we recommend fi rst copying the already
tested programming of the fl ight phase "Normal" to the
other fl ight phases. This is carried out in the menu …
"Copy / Erase" (page 64)
=>
=>
=>
=>
=> =>
=>
Copy flight phase
Erase model
Copy model–>model
Expor t to SD
Impor t from SD