21
Kaleido-MX (3RU)
Quick Start Guide
settings, information about your housing frame, the input cards and the output card
you are currently connected to, as well as date and time settings.
9 Under
General
, type the name you wish to use for your system.
If there are more than one multiviewer in the same network environment, it is
important to assign each a unique system name, so that you can tell them apart (for
example, when using a remote control panel such as the Kaleido-RCP2 or RCP-200).
Only lower-ASCII characters are allowed in the system name. Braces and tilde are not
allowed.
10 Click
Save
.
The new settings are saved locally, and XAdmin reminds you to click
Apply Setting
before closing your session.
Note:
Under
Ethernet
, you may review the IP addresses, network mask,
gateway settings, and the detected connection speeds and duplex modes.
Should you wish to make any further changes to the network settings, you
may find it more convenient to use XAdmin’s System configuration page,
from now on.
USO
RESTRITO
