14
Setting Up Your Kaleido-MX Multiviewer
Networking Setup
5 When the display shows the desired value, press SEL repeatedly until you reach the last
position (if needed), and then press SEL once more to save your changes and return to
the previous menu level.
IP ADDRESS appears on the control panel’s display.
6 Press the [–] button.
NETWORK MASK appears on the control panel’s display.
7 Repeat
step 4
and
step 5
to configure the netmask.
8 Once you have set the network mask, press the [–] button again.
GATEWAY appears on the control panel’s display.
9 Repeat
step 4
and
step 5
to configure the gateway.
10 Once you have set the gateway, press the CONTROLLER button to exit the controller’s
menu.
The Densité controller restarts.
Enabling the CPU-ETH2 Automatic Restore Feature
To enable the CPU-ETH2 automatic restore feature
1 On the Densité frame’s local control panel, press the CONTROLLER button.
2 Press the [–] button repeatedly until RESTORE POINTS appears on the display, and then
press the SEL button.
3 Press the [–] button repeatedly until DEFAULT ACTION appears on the display, and then
press the SEL button.
• If the control panel’s display shows UPDATE SETTINGS, then the automatic restore
feature is already enabled.
• If the control panel’s display shows KEEP SETTINGS, navigate to UPDATE SETTINGS
by pressing the [–] button, and then press the SEL button to apply your change.
4 Press the CONTROLLER button to exit the controller’s menu.
Configuring the Network Settings for a Single- or Dual-Head Kaleido-MX
To configure the network settings for a Kaleido-MX with one output card
1 Press the Select button on the front edge of the
output
card.
Note:
Pressing ESC when the input focus is in the first position returns to
the previous menu level. Pressing SEL when the input focus is in the last
position saves the changes and returns to the previous menu level.
IMPORTANT
Make sure the controller’s internal clock is set to the correct date and
time.
The clock settings will persist for 10 days after a power loss. Should you later
need to change the time on a CPU-ETH2 controller, then you will have to
restart any multiviewer system housed in the same frame. Refer to the
Densité CPU-ETH2 Enhanced Ethernet Controller Card Guide to Installation
and Operation, for more information.
USO
RESTRITO
