9
Kaleido-MX (3RU)
Quick Start Guide
You can now proceed with the networking setup (see
Step 2: Networking Setup
, on
page 11).
Changing the Output Resolution
To change the display resolution from the Densité controller’s local control panel
1 Press the Select button on the front edge of the
output card
whose heads you wish to
configure.
The Status LED on the selected card flashes orange, and the associated control menu
appears on the LCD display of the Densité frame’s local control panel.
2 On the local control panel, press the [–] button twice, until RESOLUTION appears on the
LCD display.
IMPORTANT
Make sure to connect your Densité controller and output cards to the same
subnet, and that your Ethernet switch remains isolated from the rest of your
network (consult your network administrator if necessary) until all required
networking setup is complete.
IMPORTANT
Within a Kaleido-MX system, all output heads must be configured with the
same refresh rate. If your system is referenced, then the heads’ refresh rate
must also match the reference signal's refresh rate. If you must monitor 50 Hz
input signals on 60 Hz displays (or vice-versa), then do not reference your
system.
Select button
Status LED
USO
RESTRITO
