9. If you previously uninstalled SNFS manually because SNFS was on C:, copy directories/files
from C: to D:, overwriting files on D:, as follows.
a) Copy the
C:\SNFS\config
directory to
D:\SNFS\config
.
b) Copy the
C:\SNFS\data
directory to
D:\SNFS\data
. This directory can be large, so allow
adequate time to complete the copy operation.
c) A restart is required to put the change into effect. If you do a subsequent upgrade task that
also requires a restart, that restart is sufficient. Otherwise restart now.
d) After the entire K2 SAN upgrade process is complete, test media access. If successful, delete
the
C:\SNFS
directory and its files on the K2 Media Server.
Verify/upgrade switch firmware
Do not do this task if:
•
Your HP ProCurve 29xx series switch already has the current required firmware version.
Do this task if:
•
Your HP ProCurve 29xx series switch does not have the current required firmware version.
Refer to compatibility information earlier in these release notes for firmware version requirements.
1. Telnet to the switch and login with the administrator username and password.
2. At the switch console command (CLI) prompt, type the following, then press
Enter
:
menu
If prompted to save the current configuration, answer no (press the n key) to proceed.
The main menu opens.
3. From the main menu, tab to
Command Line (CLI)
and press
Enter
. The command prompt appears.
4. Check the version of firmware on the switch. To do this, type the following, then press
Enter
:
show flash
Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 6737518 07/25/08 T.13.23
Secondary Image : 5886358 10/26/06 T.11.12
Boot Rom Version: K.12.12
Current Boot : Primary
5. Check the Primary Image Version and refer to compatibility information earlier in these release
notes. If instructed to change the firmware on the switch, do so before continuing.
Related Links
Upgrading firmware on HP switch
on page 27
Configuring QOS on the GigE switch
on page 28
54
K2 Version 7.3.8 Release Notes & Upgrade Instructions
23 November 2010
Upgrading K2 systems
