GRAPHTEC FC5100A-100, Руководство пользователя

Страница: 61 / 201

Preparing to Cut: Changing Feed Speed
61
T
O
C
HANGE THE
P
OUNCE
O
FFSET
• Press the F4 key to change OFFSET. The blinking cursor indicates that you can
change the setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 99.
• If all of the parameters are set, press the ENTER key to register your setting.
NOTE: For the pounce condition, the cutter offset refers to the spacing between holes
in mm units.
Changing Feed Speed
This function allows you to change the media feed speed from SLOW to NOR-
MAL. In the case of selecting ROLL-1 and SHEET on the media type menu, the
plotter uses SLOW to ensure the accuracy of the leading and trailing edges of the
media. After the initialization, the feed speed can increase once the grit rollers
and the pinch rollers secure the media. Always select SLOW for heavy media or
media with a slippery surface, otherwise select NORMAL to shorten the initializa-
tion time. Remember that the media will back up at the pen up speed when NOR-
MAL is selected.
For details see FEED – Advancing Media.
When the media set lever is lowered, the following menu appears on the display:
• Press the F4 key.
• Press the F3 key to select INITIAL FEED SPEED.
SET ........... 12
CONDITION 8 ...... 30
.......... 4
POUNCE ... 1
LOAD MEDIA!
INITIAL MENU> .
AUTO REG. MARK> .
AUTO PRE FEED> .
INITIAL FEED SPEED> .
INTERFACE> .