GRAPHTEC FC5100A-100, Руководство пользователя

Страница: 47 / 201

Preparing to Cut: Select the Media Type
47
CUT AREA shows the effective cut area that is determined by the position of the
pinch roller and the page length setting.
NOTE: After initializing the plotter by choosing ROLL-1 or ROLL-2, use the FEED
function to pre-feed the length of media needed for the job. This embosses the
grit roller pattern onto the media to help prevent media skewing or excessive
system torque which triggers the position alarm. The position alarm resets the
system, or if the system is overloaded, it triggers the product’s circuit protection
causing the power to shut down.
Should the system overload causing the power to shut down, turn off the power
switch and unplug the power cord. Wait 5 to 10 minutes, reconnect the power
and turn on the system. For more information, see
Chapter 6 Test Modes and
Troubleshooting .
SHEET
SHEET detects the width and both the leading and trailing edges of the media.
Press the F3 key to select SHEET
The initialization routine is executed to determine the paper size and origin
point.
CUT AREA shows the effective cut area that is determined by the position of the
pinch roller and the page length setting.
CONTINUE
The CONTINUE function is useful and will save time if you intend to cut a large
quantity of the same-size media. This selection is available from the second initial-
ization after turning on the power. CONTINUE does not appear in the media selec-
tion menu on the first initialization after turning on the power. The plotter assumes
that the current media is the same size as the last media that was loaded on the
plotter and does not detect the media’s edges. To use CONTINUE effectively, set
the media so that the current pen carriage position can be located at the same
place as it was on the last media.
CUT AREA
X=2000mm Y=730mm
ROLL-1>
*
ROLL-2>
*
SHEET>
*
CONTINUE>
*
CUT AREA
X= 830mm Y= 730mm