Graco ToughTek F680e, Инструкция по эксплуатации

Страница: 25 / 54

Shutdown
Shutdown Shutdown Shutdown
NOTICE NOTICE
NOTICE
To prevent rust, never leave water or water-based
fluid in pump overnight.
To shut down the sprayer, flush the system. See
Flush, page 16 .
Turn main power disconnection (DD) OFF.
WWLL DD
Corrosion Corrosion Corrosion Protection Protection Protection
NOTICE NOTICE NOTICE
To prevent rust, never leave water or
water-based fluid in pump overnight.
NOTICE NOTICE
NOTICE
Material left on the throat seal can dry out and
damage the seal. Always stop the pump at
the bottom of the stroke to avoid damage to
the throat seal.
Always flush the pump before the material dries on
the displacement rod. For longer periods of time
where the pump is not in use, pump oil through the
pump lower, then relieve the pressure. Leave oil in
the pump to protect the parts from corrosion.
Lifting Lifting Lifting Instructions Instructions Instructions
NOTE: NOTE: NOTE: When lifting the unit, use a forklift and always
lift from the rear of the system. The center of mass
in the F680e is in the middle of the sprayer. With
shorter forklifts or when driving the forklift over rough
terrain while carrying the F680e, install the forklift
stabilization kit 24Y479. These support brackets
will hold the F680e onto the forks and prevent the
sprayer from falling, tipping, or bouncing off the forks.
The forklift stabilization kit (24Y479) is not included
in the base models.
3A3110K 25