10. Circulate clean water:
a.
Fill the system hopper with clean water.
b.
Use a scrub brush to scrub the walls of the
hopper.
c.
Switch the pump control switch (AA) to ON to
begin circulating water.
d.
While pumping, turn the hydraulic pressure
control (S) knob to a lower setting and open
the fluid drain/purge valve (C). Allow the
water to flush out any material to prevent
material hardening in the valve. Once
the water appears clean, close the fluid
drain/purge valve (C).
e.
Turn the pump control switch (AA) to OFF.
f.
Place applicator outlet in a waste container.
g.
Turn the pump control switch (AA) to ON to
dispense into waste container.
h.
Dispense into waste container until hopper
is almost empty, then turn the pump control
switch (AA) to OFF.
i.
Repeat this entire “Circulate clean water”
step one more time to ensure system is
thoroughly flushed.
11. Remove the remaining material
with a hose clean-out ball (see
Replacement Parts and Accessories, page 47
for
a list of available clean-out balls and the
appropriate hose sizes to use them on):
a.
Remove the applicator from the end of the
hose and place the hose outlet back in the
waste container.
b.
Remove the hose inlet from the fluid outlet
(B) and place a hose clean-out ball within
the hose inlet. The ball must be wetted with
water before inserting.
c.
Reattach the hose to the fluid outlet (B) and
switch the pump control switch (AA) to ON
to resume flushing the hose. Make sure the
hopper is sufficiently full of water to keep
pushing the ball out.
d.
The hose clean-out ball will be pushed out
of the hose after several minutes. Once
the ball is pushed through the hose, switch
the pump control switch (AA) to OFF and
repeat the entire process listed in step 11
one additional time to ensure the system is
thoroughly flushed.
NOTE:
NOTE:
NOTE: Always use the appropriately sized
clean-out ball for the hose size being
flushed/cleaned.
NOTICE
NOTICE
NOTICE
Material left on the throat seal can dry out and
damage the seal. Always stop the pump (park
the pump) at the bottom of the stroke to avoid
damage to the throat seal.
12. Turn compressed air on to blow out any material
that may have back-flowed into the air lines while
flushing (this will prevent air line pack out).
3A3110K
17
Содержание ToughTek F680e
