Attach
Attach
Attach Power
Power
Power Cord
Cord
Cord
Improper wiring may cause electric shock or other
serious injury. All electrical wiring must be done
by a qualified electrician and comply with all local
codes and regulations.
1.
Strip outer jacket of power cord to expose 8 in.
(20.3 cm) of conductors.
NOTE:
NOTE:
NOTE: Strip individual conductors and add
ferrules as necessary.
2.
Attach the power cord to the disconnect block
(PD) located in the electrical control box (R).
Bring the power cord into the electrical control
box through the strain relief (SR).
3.
Install the power cord as shown below.
200–240
200–240
200–240 VAC,
VAC,
VAC, 1
1
1 phase:
phase:
phase: Use a screwdriver to
connect two power leads as shown.
L1
L2
WWLL DD
4.
Connect the green ground wire to the ground
terminal (GT).
5.
Make sure the strain relief is tightened. Close
the electrical control box.
14
3A3110K
Содержание ToughTek F680e
