Start
Start
Start and
and
and Adjust
Adjust
Adjust the
the
the Pump
Pump
Pump
Keep hands and fingers away from the ram plate,
pump fluid inlet, and lip of the fluid container when
raising or lowering the ram to reduce risk of serious
injury from moving parts.
NOTICE
NOTICE
NOTICE
To prevent pinching or damaging the seal during
drum insertion, only inflate the seal when the top
lip of the ram plate is at, or below, the top edge of
the drum.
To prevent the seal from restricting smooth
movement of the ram plate within the drum, only
inflate the seal until it makes contact around the
perimeter of the drum.
1.
For
For
For Exposed
Exposed
Exposed Control
Control
Control Panel:
Panel:
Panel:
a.
Connect pump outlet fittings and hose (not
supplied).
NOTE:
NOTE:
NOTE: Be sure all components are
adequately sized and pressure rated to meet
the system’s requirements.
b.
Using the ram director valve, lower the
ram plate into the drum until it contacts the
product.
c.
If the system is equipped with an inflatable
seal and the ram plate is located far enough
into the drum to properly inflate the seal,
inflate it now. If the ram plate is not far
enough into the drum for seal inflation, wait
until enough product has been evacuated to
lower the level of the ram plate in the drum
before inflating.
d.
Move the air motor slider valve to the 1
(open) position. Observe that the pump
begins to operate. Adjust air motor air
pressure as needed.
e.
Move the ram director valve to the down
position. Observe that the ram lowers
as product is evacuated. Adjust ram air
pressure as needed.
f.
If using an inflatable seal and it has not yet
been inflated and the ram plate has lowered
far enough into the drum, inflate it now.
g.
Using the pressure settings for the various
functions, fine-tune the pressures as needed.
NOTE:
NOTE:
NOTE: Increase air pressure to the ram if the
pump does not prime properly with heavier
fluids. Decrease air pressure if material is
forced out around the ram plate seal.
2.
For
For
For Enclosed
Enclosed
Enclosed Pneumatic
Pneumatic
Pneumatic Control
Control
Control Panel:
Panel:
Panel:
a.
Connect pump outlet fittings and hose (not
supplied).
NOTE:
NOTE:
NOTE: Be sure all components are
adequately sized and pressure rated to meet
the system’s requirements.
b.
Using the ram position control switch, lower
the ram plate into the drum until it contacts
the product in the drum.
c.
If the system is equipped with an inflatable
seal and the ram plate is located far enough
into the drum to properly inflate the seal,
inflate it now. If the ram plate is not far
enough into the drum for seal inflation, wait
until enough product has been evacuated to
lower the level of the ram plate in the drum
before inflating.
d.
Move the air motor control switch to the run
position. Observe that the pump begins to
operate. Adjust air motor air pressure as
needed.
e.
Move the ram position control switch to the
down position. Observe that the ram lowers
as product is evacuated. Adjust ram air
pressure as needed.
f.
If using an inflatable seal and it has not yet
been inflated and the ram plate has lowered
far enough into the drum, inflate it now.
g.
Using the pressure settings for the various
functions, fine-tune the pressures as needed.
NOTE:
NOTE:
NOTE: Increase air pressure to the ram if the
pump does not prime properly with heavier
fluids. Decrease air pressure if material is
forced out around the inflatable seal.
20
3A5402J
Содержание SaniForce SDU A01AAA1AA0C21
Страница 74: ...Notes Notes Notes Notes 74 3A5402J...
