Graco Reactor E-30i, Запасные части

Страница: 52 / 158

Repair
3. Replace cap and tighten past the safetylatch
position.
4. Press start button twice on the engine
control module.
5. Turn main power switch on.
6. Inspect coolant flow in sight glass (SG) for
bubbles and to verifythat the coolant is flowing.
7. Inspect coolant loops for leaking fittings or valves.
8. The coolant has reached operating temperature
when the radiator fan turns on. When the fan
turns on, turn the main power switch off.
9. Press to stop the generator.
10. After the coolant system temperature lowers to
ambient temperature, refill or add coolant to the
expansion bottle (HB) cold level indicator line.
11. Turn off manual valve switch (MV) to close the A
and B heat exchanger control valves (VA, VB)
and bypass control valve (VC).
Note
When the manual valve switch (MV) is
in the off position, the load center (LC)
LEDs onlyturn on when the system
opens the valves.
12. If necessary, refill or add coolant to the expansion
bottle (HB) cold level indicator line. See Fig 8 .
Refill Engine Coolant Loop
Refill the engine coolant loop when the coolant is
below the cold level line at ambient temperature.
To avoid burns, do not perform maintenance on
the coolant system until the coolant system has
reached ambient temperature.
Onlyuse coolant solutions that are compatible with
the system. See Coolant Specifications, page 53 .
1. Perform Shutdown, page 49 .
NOTICE
Do not refill with drained coolant. Use only
fresh, new coolant to avoid contaminants.
NOTICE
Do not use any“stop leak” additives to prevent
plugged filters and small orifices.
NOTICE
Do not interchange the two caps between
the radiator and coolant bottle. The caps
have different pressure ratings that affect the
overflow.
2. Remove the engine radiator coolant cap (RC)
and fill until the coolant reaches the bottom
of the neck. See Fig 8 . Replace cap. See
Coolant Specifications, page 53 .
3. Remove the cap from the engine coolant loop
bottle (EB) and fill until the coolant is at the hot
level. Replace cap.
4. Press start button twice on the engine
control module.
5. Turn main power switch on.
6. Inspect coolant loops for leaking fittings or valves.
7. The coolant has reached operating temperature
when the radiator fan turns on. When the fan
turns on, turn the main power switch off.
8. Press to stop the generator.
9. Add more coolant to expansion bottle (EB)
after the coolant system temperature lowers to
ambient temperature. Repeat until coolant level
stays at cold level when at ambient temperature.
It maytake a few cycles to remove all air out of
coolant system.
52 3A1706K
All manuals and user guides at all-guides.com