Fill
Fill
Fill Screen
Screen
Screen
NOTE:
NOTE:
NOTE: This screen is visible only if manual override
is enabled on
.
The Fill screen displays the following information for
the pump assigned to the current component:
• Material. Select Component A, B, C, or D. The
pump animation at the top of the screen will show
the selected material.
• Flush Line (only for systems with color change).
Select this box if you want to flush the specified
material line. The system uses flush sequence 1.
To prime the pumps and fill the lines, first read
Prime and Fill the System, page 21
1.
Press the Edit softkey
to open the screen
for editing.
2.
Select Component (A).
3.
If the selected material is not already loaded,
press the Prime softkey
. The system will
prime Component (A) into the selected pump
through the selected color valve and out the
outlet dump valve.
4.
Press the Fill softkey
. The system will
attempt to fill the Component (A) lines until the
user presses Stop
. Trigger the gun into a
waste container.
5.
Repeat for all components.
Pre-Fill
Pre-Fill
Pre-Fill Pump
Pump
Pump
The pump pre-fill option is available for pumps that
have color change, but only a single material (A, B,
C, or D). The pre-fill option may be used for pumps
that remain filled with material when the system was
powered down.
Press the Pre-Fill softkey
to “prime” the
pump without flushing or expelling any material
unnecessarily.
Figure 25 Fill Screen, Component (A) Selected
Figure 26 Fill Screen, Solvent Selected
Figure 27 Fill Screen, Pre-Fill Pump Option
3A6287E
63