Operation Using Advanced Display Module (ADM)
Color
Color
Color Change
Change
Change System
System
System
1.
Relieve the pressure.
See
Pressure Relief Procedure, page 20
2.
Attach regulated solvent supply lines as follows:
• Mix
Mix
Mix of
of
of multiple
multiple
multiple and
and
and single
single
single component
component
component pumps:
pumps:
pumps:
On pumps that have color change, do not
disconnect the component supply line from
the inlet manifold of the pump. Instead
connect a regulated solvent supply line to the
designated solvent valve on the component
valve manifold. On pumps that do not have
color change, disconnect the supply line from
the inlet manifold of the pump, and connect a
regulated solvent supply line.
• Multiple
Multiple
Multiple components
components
components on
on
on all
all
all pumps:
pumps:
pumps: Connect
regulated solvent supply lines to the designated
solvent valves on each of the component valve
manifolds. Do not connect solvent supply lines
directly to the inlet manifolds of the pumps.
3.
Set the solvent supply pressure regulator at the
lowest pressure possible. Generally a setting
of 25–50 psi (0.18–0.35 MPa, 1.8–3.5 bar) is
sufficient.
4.
On the ADM, go to the Fill screen. Select
Component A. Enter the component number in
the box to the right.
5.
Select the Flush Line box.
6.
If the solvent is not already loaded, press the
Prime softkey
. The system will prime
solvent into the selected pump and out the outlet
dump valve.
7.
Press the Fill softkey
. The system will flush
the selected Component line with the solvent
until the user presses Stop
.
8.
Hold a metal part of the gun firmly to a grounded
metal pail. Trigger the gun until clean solvent
dispenses.
9.
Repeat for each component line.
10. Relieve the pressure.
See
Pressure Relief Procedure, page 20
Shutdown
Shutdown
Shutdown
1.
Flush out the mixed material to avoid potlife errors
and fluid setup in the lines. See
.
2.
Follow the
Pressure Relief Procedure, page 20
.
3.
Close the main air shutoff valve on the air supply
line and on the control box.
4.
Press
on the Display Module to turn off
power to the pumps.
5.
Shut off system power (0 position).
3A6287E
23
