Maintenance
333587D
51
Pump Maintenance Screen 2
Use the ADM’s Directional Keypad (CH) to navigate to
screen 2. This screen shows the driver calibration
status and the driver usage histogram.
A
indicates that the driver is calibrated and ready to
operate. A
indicates the driver must be calibrated
before operation.
The histogram represents how hard the driver has been
run in its lifetime. Each cycle falls between 0% and
100%. For example, five pump cycles at maximum
force would be all the way to the right at 100%. Five
pump cycles at minimum force would be all the way to
the left at 0%.
Press the
soft key to toggle between the
histogram displaying the total lifetime cycles and the
cycles since the last reset.
Press the
soft key to enter editing mode.
When in editing mode with the Cycles Since Last Reset
histogram showing, pressing the
soft key on the
right resets the histogram.
Press the
soft key to show the Driver Calibration
screen. Press the
soft key to begin driver
calibration. Refer to your driver manual for calibration
instructions.
Press the
soft key to exit editing mode.