Device Description HG G-19603ZA | English, Revision 03 | Date: 31.03.2021
14
Chapter 3 – Mounting
Figure 8
Possible mounting pos. for the magnet sensor when using an optional distance piece
If the magnet sensor has to be mounted side-inverted (aka backwards) the output
voltages for the left and right deviations may be interchanged compared to what the
vehicle control expects. In this case the output voltage AOUT1 can be inverted inside
the sensor, see 6.4.3 on page 28.
3.2.3 Connection Cable (assembled on one side)
Connect the sensor to the vehicle control. For this the connectors ST 1 and ST 2 are
used. The assignment of the pins is shown in section 5.2 on page 21. The following
optional cable extensions can be used.
Table 3
Accessories / cable extensions
Order no.
Description
HW CAB00001
PWR/USB: Cable PUR, 5m with one M12 angle coupling, 5
pin, A coded, one end open
HW CON00055
CAN1: CAN terminator
Plug M12 5 pin, A coded
HW CON00100
CAN1: Closing plug M12
5 pin, A coded, shieldable
HW CAB00064
CAN2: CAN Bus cable,
10 m, with shielding, one-sided M12 socket straight
Magnet tape
Roadway
Optional
Magnet sensor
Vehicle body
Direction of travel
distance piece
(material non
ferro-magnetic)
