Gotop RigiScan Plus, Руководство пользователя

Страница: 42 / 74

-42-
R
IGI
S
CAN
®
( User Guide )
4. Push the Tension Guide into the Tension Guide housing on the monitor and turn approximately
1/4 turn counterclockwise until the metal pin moves out of the slot at the far right of the housing.
5. Pull slowly and gently on the Tension Guide boot to remove the Tension Guide and cable from
the monitor.
4.2 Removing the Tension Guides
(continued)
4.3 Installing the Loop Covers
1. Insert the snap end of the Tension Guide cable securely into the feed -
er tube at the “Y” connect end of the loop cover. (See Figure 4-3A)
2. Hold the loop-cover “Y” connect in one hand and gently pull the
feeder tube and cable through the loop cover until the “Y” connect is
adjacent to the threaded end of the Tension Guide.
3. Hold the Tension Guide boot in one hand, the “Y” connect in the oth -
er and screw the “Y” connect clockwise until it is securely fastened to
the Tension Guide. Do not over tighten. (See Figure 4-3B)
4. Grasp the snap end of the loop cover and remove the feeder tube.
(See Figure 4-3C)
5. Close the loop by holding the fabric directly behind the release tab
and pushing the snap into the receptacle on the “Y” connect. (See
Figure 4-3D)
Fig. 4-3A
Fig. 4-3B
Fig. 4-3C
Fig. 4-3D
NOTE
: The loop covers are supplied with a clear plastic feeder tube inside the loop. The feeder
tube is required for installing the loop cover. DO NOT remove the feeder tube until directed
to do so.