Gorenje HEC50EP, Инструкции по использованию и подключению

Страница: 26 / 26

Instructions for Use
57
Leveling the cooker
The height of the cooker with the support is 90
cm, and without support it is 85 cm. Left and right
side of the support is equipped with two wheels to
facilitate relocation. In the front part, on both
sides there are two adjustable screws, used to
level the cooker and adjust its upper edge in line
with the adjacent kitchen furniture.
Adjustable legs are accessible when the drawer
is pulled out. Adjust the position of the cooker by
turning the legs in one direction or another.
Adjustable legs will be turned easier if the
appliance is somewhat lifted up and tilted.
Drawer
The drawer is protected against accidental
opening. If you want to open the drawer slightly lift
it first and then open it. In case you want to
remove it from the appliance pull it out until it
stops, lift it and again pull it out.
Never store inflammable, explosive or heat
sensitive material in the drawer.
Place the storage drawer by inserting the rear
bottom slide into the cooker guides.
Instructions for Connection
Important Warning
•
Before any intervention, disconnect the power
supply. Considering the mains voltage the
appliance should be connected in accordance with
one of the following connecting possibilities.
Protective conductor (PE) must
be put on terminal pin .
•
Connection should be performed by qualified fitter
only.
•
Before attempting to connect the appliance check
wheter the voltage indicated on rating plate
corresponds to mains voltage.
•
The rating plate of the cooker containing general
data is at the edge of the oven and is visible when
the door is open
•
When the appliance is connected to power supply
switch on all heating elements for about 3 minutes
in order to check their operation.
•
The electric installation should have switching
device that disconnects the aplliance from mains
in any pole. In open position the distance between
contacts should be at least 3 mm. LS switches
and fuses are considered to be good protection.
•
This appliance can be connected to three-phase
or two-phase power supply 3N AC
400 V with neutral conductor, but may as well be
conected to AC 230V.
•
When selecting the connector, consider the
capacity of the power supply and fuses. Supply
cord should be directed through relief device
which protects the cord against accidental pulling
out.
•
Terminal pins are accessible when you remove
the rear wall of the appliance.
•
The following can be used for connection:
−
rubber connection cables (type HO 5RR-F
with green-yellow protective conduit)
−
PVC insulated connection cables (type
HO 5VV-F with green-yellow protective
conduit) or
−
any other suitable cable of equal or better
properties.
Connection Terminal
Bridges are inserted between connectors N-N on
terminal pin.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE
ON THE OPERATION OF THE APPLIANCE.