Instructions for use and connection
39
In such cases the display indicates
»0«
if the
temperature is below 60°C or
»H«
if the
temperature is above 60°C (see chapter
"Remaining heat")
To unblock the safety stop, first switch the hob off
by touching the ON/OFF sensor, then reactivate
the hob by touching the same sensor again.
Double ring hotplate
Front left and rear right hotplates are designed as
double hotplate rings, providing the possibility of
to activate such hotplate surface as to suit the
diameter of the dish used, by switching on either
the inner hotplate ring or also the extended
exterior ring.
Switching the extended exterior
hotplate ring on and off
•
Select the desired hotplate by touching the
relevant ON/OFF sensor
(2)
(the decimal dot
(13)
is on).
•
Adjust the heating range by the sensor
»-» or
»+« (4 or 5).
•
By touching the extended hotplate sensor
(6)
switch on the complete hotplate (signal lamp is
on
(10).
•
Next touch of the extended hotplate sensor
(6)
will switch the extended ring off (signal lamp
(10)
goes off).
Blocking the hob operation
After the hob had been switched on by the
ON/OFF sensor
(1)
you may block the functioning
of the complete hob
(9).
This prevents the
accidental activation (children safety). The
blocked mode is signaled by the hob blockage
control lamp
(12).
The hob remains blocked also after the
repeated activation of the hob by the
ON/OFF sensor
(1)
until the blockage is
removed by repeated touching of the
blockage sensor
(9)
and the blockage signal
lamp
(12)
goes off.
