Instructions for use and connection
44
Safety functions and error display
The hob is equipped with the overheat safety
sensors. When they are activated they turn off the
hotplates nearest to the control board.
Error, possible cause, remedy
•
Constant sound signal or Err 33
−
Water is spilled over sensor surface
(Wipe the sensor surface)
•
Flashing »H«
−
Hot pan is placed above the sensor surface.
(Wait until normal sensor temperature is
regained.).
−
Gaskets on heating elements are damaged.
(Wait until normal sensor temperature is
regained.).
In case any other error signal is displayed,
switch the hob off immediately, disconnect it
from the mains and contact your nearest
service center.
Accessories
Deep frying pan
is used for baking pastry and for
roasting meat.
Do not insert the deep frying pan into the bottom
guide.
Enameled tray
is used only for baking pastry.
Put the food in a pan and place it on the shelf.
Food can be placed directly on the
wire shelf
as
well, but don't forget to insert the drip tray under it
to collect the drippings.
Protective shield
is used when you cook in the
oven with the door open (infra red grilling).
The pull-out slides
enable you to choose 3
different shelf positions for baking.
Put the grid or baking pan carefully on the
selected pair of pull-out slides between the
elements restricting the baking pan. This can be
done when the pull-out slides are pushed into the
oven or their relevant pair is drawn from the oven.
When these slides are drawn out, check whether
the baking pan or the grid is correctly placed on
the pull-out slides and then push them slowly into
the oven. Close the door ONLY when the slides
will be entirely inserted in the oven.
WARNING
: be careful not to get burnt as during
preheating and baking process the pull-out slides,
grids and baking pan can heat up strongly.
If baking pan or grid is pulled out when baking by
the pull-out slides, please, use the baking handle
or protection glove provided.
Before closing the oven door check if the pull-out
slides are pushed well into the oven.
Warning
: make sure the appliance is installed in
a perfectly horizontal position, otherwise the
telescopic guides may run out of the oven when
the door is open.
Place the
grease filter
always in position when
the oven is in the heating mode with the fan on,
since the possibility to stain the oven walls is the
biggest (spurting of fat during roasting). This way
the fan is also protected from staining.
When removing the tray from the oven, use the
handle
. Hook the handle to the edge of the tray
and pull it out slightly lifted. Use the handle for
removing the wire shelf as well.
The rear wall of the oven is coated with
catalytic
coating
which can be installed or removed by a
qualified technician only.
