GORBEL G-Force iQ2 Series, Руководство по обслуживанию

Страница: 85 / 138

G-Force® & Easy Arm Q2 - iQ2 Service Manual Gorbel Inc.
Revised 5/21 9 - 32
Procedure S-2A. Remote Mount Cap Sub-Assembly Removal
Note
:
This procedure assumes the handle has already been removed from a remote mount bracket or similar
mounting device.
1. Remove M16 hex head cap screw (HHCS), fl atwasher and lockwasher from the top of the handle assembly.
2. Slide the remote mount cap o ff the handle shaft. Note the orientation of the internal electrical connector located
below the remote mount cap.
Procedure S-2B. Remote Mount Cap Sub-Assembly Replacement
1. Slide the remote mount cap onto the handle shaft. Note the orientation of the internal electrical connector locat-
ed below the remote mount cap.
2. Position the handle assembly into the remote mount bracket (if applicable) and install M16 hex head cap screw
(HHCS), fl atwasher and lockwasher onto the top of the handle assembly.
Diagram S-2. Remote Mounted Sliding Handle Remote Mount Cap Sub-Assembly Removal and Replacement
2x Flatwasher, M16, ZNPL
(
01310
)
Remote Mount Cap
Sub-Assembly
(
74252
)
(see inset)
2x HHCS, M16 x 2 - 33mm, CL 8.8
(
74230
)
2x Lockwasher, M16, ZNPL
(
00212
)
Connector Nut
Remote Mount Slide Handle Cover
(
74224
)
Hex Standoff, 6mm x 12mm, M4
(
65083
)
SHSS, M6 x 1-8
(
65099
)
PCB Slide Auxiliary Out
(
74233
)
Lockwasher, M3, ZNPL
(
65051
)
PHMS, M3x0.5-20,
ZNPL
(
65082
)
Note: Numbers in
Parentheses are
Gorbel® Part Numbers
Housing Sub-Assembly
(
74247 / 74248
)
Handle Transducer Sub-Assembly
(
74246
)
External Snap Ring
(
65069
)
Grip & Shaft Sub-Assembly
(
74245
)