GORBEL G-Force iQ2 Series, Руководство по обслуживанию

Страница: 88 / 138

G-Force® & Easy Arm Q2 - iQ2 Service Manual Gorbel Inc.
Revised 5/21 9 - 35
Procedure S-4A. Handle Grip and Shaft Assembly Disassembly
1. Remove the swivel or remote mount cap sub-assembly. Refer to Procedure S-1A or S-2A.
2. Remove the housing sub-assembly. Refer to Procedure S-3A.
3. Remove the spring pin from the hex jam nut and handle shaft.
4. Remove the hex jam nut from the handle shaft.
5. Slide the spring sleeve down o
ff the bottom portion of the handle shaft.
6. Slide the fi rst bearing sleeve down o ff the bottom portion of the handle shaft.
7. Slide the compression spring down o ff the bottom portion of the handle shaft.
8. Slide the second bearing sleeve down o ff the bottom portion of the handle shaft.
9. Slide the grip assembly down o ff the bottom portion of the handle shaft.
Note: There are a total of (12) ball bearings seated in (3) separate grooves in the handle shaft. These are normally
coated with grease and should remain in place however they can fall out if the amount of grease has decreased
over time.
Procedure S-4B. Handle Grip and Shaft Assembly Reassembly
1. Install the grip assembly up from the bottom portion of the handle shaft and position the grip assembly so that
the ball bearings can be installed into the grooves of the handle shaft from the top of the grip assembly.
2. Slide the second bearing sleeve up from the bottom portion of the handle shaft.
3. Slide the compression spring up from the bottom portion of the handle shaft.
4. Slide
the fi rst bearing sleeve up from the bottom portion of the handle shaft.
5. Slide the spring sleeve up from the bottom portion of the handle shaft.
6. Install the hex ham nut from the handle shaft.
7. Install the spring pin into the hex jam nut and handle shaft.
8. Replace the housing sub-assembly. Refer to Procedure S-3B.
9. Replace the swivel or remote mount cap sub-assembly. Refer to Procedure S-1B or S-2B.
Handle Transducer Feature
2x Spring Bearing
(
74212
)
Note: Numbers in
Parentheses are
Gorbel® Part Numbers
Pin Hole
Spring Sleeve
(
74213
)
Compression Spring
(73019)
Coiled Spring Pin, M4x9.5mm
(
65087
)
12x Hardened Precision Ball,
6mm (
74227
)
1/4” NPT Thread
Hex Stando ff , 6mm Hex
(
74228
)
Shaft
(
74201
)
Hex Jam Nut,
M24x3.0
(
74226
)
Grip Assembly
(
74234
)
Diagram S-4
.
Handle Grip and Shaft Assembly and Disassembly.