GORBEL G-Force iQ2 Series, Руководство по обслуживанию

Страница: 118 / 138

G-Force® & Easy Arm Q2 - iQ2 Service Manual Gorbel Inc.
Revised 5/21 9 - 65
Removal & Replacement Procedures
G360™
Procedure G-1A. G360™ Disassembly Procedure
1. Remove M16 x 2 MM hex head cap screw (HHCS) and M16 Belleville washer from G360™ assembly. Note the
orientation of the Belleville washer, concave side down.
2. Slide the swivel sub-assembly o ff the collector shaft. Note: Set aside the swivel sub-assembly with the PCBs
facing upward to avoid damaging them.
3. Remove electrical connector nut from the slip ring PCB.
4. Remove the (2) M2 Phillips head machine screws (PHMS) that secure the slip ring PCB to the collector shaft.
5. Remove the air extension and nylon washer from collector shaft.
6. Remove (3) M3 socket head cap screws (SHCS) and M3 lockwashers from the collector shaft and slide the
collector shaft out of the cover.
Procedure G-1B. G360™ Reassembly Procedure
1. Slide the collector shaft into the cover and secure it using the (3) M3 socket head cap screws and M3 lockwash-
ers. Note the alignment of the output connector to the cover opening.
2. Install the air extension and nylon washer into the collector shaft.
3. Assemble the slip ring PCB to the collector shaft with (2) M2 Phillips head machine screws (PHMS).
4. Install the output connector nut on the slip ring PCB.
5. Slide the swivel sub-assembly onto the collector shaft. Carefully align connectors using the alignment grooves
in the cover.
6. Install the M16 x 2 MM hex head cap screw (HHCS) and M16 Belleville washer onto the G360™ assembly.
Note the orientation of the Belleville washer, concave side down.