Goldschmidt WT 1400 P, Руководство по эксплуатации

Страница: 13 / 45

24 25
Figure 13: Operating and adjustment controls 3
Figure 14: Operating and adjustment controls 4
6.2 Operating settings
On its trolley, the machine has 2 stable positions. These are
illustrated in the following illustrations.
Figure 15: Position for tightening and loosening the sleeper
bolts
Figure 16: Position for tilting and moving the machine
6.3 Commissioning
6.3.1 Prior to commissioning
Prior to first-time commissioning (after transport or storage),
check the general external condition of the machine:
1. Check for presence and legibility of identification plate
and safety labels.
2. Check the outside and the underside of the engine for
signs of oil or fuel leaks.
3. Remove excessive dirt or foreign bodies, in particular
near to the muffler and the recoil starter.
4. Look for signs of damage, e.g. cracks and breaks.
5. Check if all guards and covers are fitted and all nuts
and screws have been tightened.
– If the engine is not in perfect condition, do not start
the engine but instead restore normal condition and/or
inform maintenance personnel.
During the first hours of operation,
it is possible for the spindle to
rotate, even if the actuation
switch is released. This is because
the electromechanical brake
must first get run in.
6.3.2 Daily commissioning
Before each daily commissioning (start-up), check the engine
for fuel and consumables before each operation.
1. Check the fuel level of the engine at regular intervals
and fill in if necessary (see Chapter 6.12.1 “Check and
fill in fuel” on page 33) .
2. Check the engine oil level and fill up if necessary (see
Chapter 6.12.2 “Check and fill in engine oil” on page 34) .
3. Check the air filter insert and clean if necessary or
replace it (see Chapter 6.13 “Check and clean the air
filter” on page X) .
Control element Function
Fuel tap To adjust the fuel feed
(2 states: left = OFF, right = ON).
Choke lever To control the air feed when
starting the engine.
(2 positions: left = OPEN,
right = CLOSED).
Throttle lever To adjust the engine speed
Engine switch Switching on the engine (2 posi-
tions: left = ON, right = OFF).
Starter handle To start the engine with a
recoil starter.
Emergency
stop button
Immediate shutdown of
the engine.
Actuation button Spindle rotation.
Direction of
rotation selector
Setting direction of spindle
rotation (2 positions: TOP = loos-
ening, BOTTOM = tightening).
Operating hours
counter
Display of operating hours.
Rotational
controller
Setting the tightening torque.
Spindle Rotating axis.
Socket wrench
insert
Connecting element between
spindle and sleeper bolt.
EN
GLISH
DEUT
SC
H
TORQUE WRENCH WT 1400 P OPERATING MANUAL
NOTE