Instruction Manual - Touch Screen
2011, 2848, 2860, 2872, and 2873 (32 oz. Pop-O-Golds)
PopClean Elite Popper -600 Series
2911, 2948, 2960, 2972, and 2973 (52 oz. Medallions)
Page 54
gmpopcorn.com
7.
Allow kettle to cool at least 1 hour, then turn the power switch OFF, and unplug unit.
8.
Dump solution into a bucket, do not spill any in the interior of machine.
9.
Rinse kettle interior with clean water and a clean cloth.
10.
Dump any water remaining into a bucket (do not spill any in the interior of machine),
then wipe the kettle interior clean with a clean dry cloth.
For an extra dirty kettle, the process may be repeated; or, after turning kettle heat OFF,
allow solution to sit in kettle overnight. The next morning, finish the cleaning steps.
11.
A Clean-In-Place Hook is located behind the kettle support arm (on operator side).
This feature safely holds the kettle in place for cleaning purposes, and allows access to
hard to reach places without removing the kettle. To remove the lid and agitator
assembly, tilt kettle into the dump position, and swing the hook into position (see
image below).
12.
With unit OFF and unplugged, use a clean SLIGHTLY damp cloth (wring ANY EXCESS
water from cloth before use) and wipe the kettle lead cord clean.
DO NOT get moisture
into the kettle lead-in cord, severe damage will result.
13.
After kettle cleaning, check to be sure the crossbar fasteners are securely tightened.
Daily Unit Cleaning Instructions
1.
Turn machine OFF, unplug unit and allow it to cool before attempting to clean.
2.
Remove any remaining popcorn.
3.
Remove the grease tray under the baffle filter and take it to the sink to clean with soap
and water, then rinse and dry.
4.
Remove the Baffle Filter and take it to the sink to clean with warm soapy water, then
rinse and allow to drain and air dry. (Reference the Filter System section for
instructions to remove and install filters.)
Clean-In-Place Hook