GEK-99044
Chapter 2. Getting Started
2-9
The paper shelf hangs on the back of the printer near the floor. The
paper rack hooks onto the two end wire loops protruding from the
rear paper exit. Use the following procedures to install the paper
handling system:
1.
Hang the paper shelf on the back of the printer in the holes
provided as shown in Figure 2-4a.
Note
The 5180 (55 dBa) Cabinet Model paper shelf attaches to a solid
metal plate. The metal plate is attached to the back of the
printer in the holes provided as shown in Figure 2-4b.
2.
Install the wickets on the shelf so the tightening knobs are facing
away from the area the paper will occupy.
3.
Slide the wickets along the shelf so the distance between the
wickets accommodates the length of the fanfold paper (form
length).
4.
Lay the V-shaped paper stacking aid on the shelf between the
wickets. This stacking aid should be used when stacks of 1000 or
more forms are anticipated. See Figure 2-4a and Figure 2-4b.
5.
Hook the paper rack onto the two end wire loops protruding from
the rear paper exit. See Figure 2-5.
Note
The 5180 (55dBa) Cabinet Model has an opening in the back of
the printer. The upper paper rack has two metal hooks, which
hang over the edge of the opening to hold the rack in place. See
Figure 2-6b.
FIGURE 2-5 REAR VIEW
5050/5100 (55dBa) CABINET MODEL SHOWN)
RIGHT END
WIRE LOOP
LEFT END
WIRE LOOP
